120 Forest Service, 44 BLM and 15 National Park Service. 122 take reservations
Winter winds the State Climate Office calls frequent 5
30 to 40 mph
With gusts to 50 or 60
Racks, armor and the Wyoming wind
Most of Wyoming’s documented routes are graded gravel and dirt rather than ledges, so armor matters less here than what you hang in the wind. With frequent winter winds of 30 to 40 miles per hour and gusts to 50 or 60, a tall rack, an awning or a roof box is a sail. Ask a fabricator to keep loads low and tight to the body.
One local item: in the Killpecker Sand Dunes the BLM requires every vehicle to carry a red or orange flag on a whip mast reaching at least eight feet above the ground, so a solid mast mount is worth adding.
When a catalog part does not exist for your vehicle, does not fit with what you already have, or is not strong enough for what you do, a fabricator builds it. Steel or aluminum, welded, finished, and mounted so the load goes into structure rather than sheet metal.
They also fix what breaks: cracked mounts, bent sliders, torn brackets and the frame damage that ends trips.
Common work
01Bumpers with winch mounts and rated recovery points
02Rock sliders and skid plates
03Roof racks, bed racks and ladders
04Swing-outs for tires, fuel and water
05Mounts for tanks, compressors and batteries
06Frame and bracket repair
How to choose a fabricator
Metalwork is easy to judge if you know where to look.
01Look at the welds, then at how the part mounts. Recovery points and sliders should tie into the frame.
02Ask whether they design in CAD or build to the vehicle, and whether you get drawings.
03Ask about material and finish. Raw, painted and powder coated parts age very differently.
04Ask if they have built for your platform before. Templates and fixtures save you money.
05Ask how a front bumper affects airbag sensors and crush zones. A shop that has done it properly will have an answer.
What to have ready before you ask for a quote
Photographs do most of the talking.
01Clear photos of the vehicle and the area the part mounts to
02What is already mounted there: winch model, lights, tire size
03What the part has to carry, and how much it weighs
04Steel or aluminum, and the finish you want
05A budget range and your timing
Questions people ask
Custom or off the shelf?
If a well-made part exists for your vehicle, it is usually cheaper and faster than custom, and a good fabricator will tell you so. Custom earns its cost when nothing fits, when parts from different makers have to work together, or when you need it stronger or lighter than the catalog offers.
Steel or aluminum?
Steel is stronger for the money, easier to repair in the field and heavier. Aluminum saves real weight on racks, skid plates and boxes, but costs more and needs a welder who works with it regularly. Many builds use both: steel where it hits rocks, aluminum where it just carries things.
Can a fabricator repair a cracked frame or mount?
Often, yes. Send clear photos with your request. A good shop will tell you whether it can be repaired properly or needs replacing.
How high is Wyoming?
From Sheridan at 3,748 feet to Gannett Peak at 13,804.
Altitude decides what your engine, your brakes and your lungs have to work with, and how late in the year the passes open.
2,0004,0006,0008,00010,00012,00014,000
Feet above sea level
Towns
PinedaleSouth end of the Wyoming Centennial Scenic Byway, on US 191 under the Wind River Range. BLM and Bridger-Teton offices.7,179 ft
LaramieOn I-80. Highway 130 runs 30 miles west to Centennial, where the Snowy Range Scenic Byway enters the forest.7,165 ft
KemmererBLM field office and a Bridger-Teton ranger district. The Big Spring Scenic Backway runs from here to Cokeville.6,955 ft
DuboisNorth end of the Wyoming Centennial Scenic Byway, on US 26/287 below Togwotee Pass. Shoshone National Forest district office.6,934 ft
RawlinsOn I-80. Its BLM field office manages the Seminoe to Alcova byway, which leaves the interstate at Sinclair, exit 219.6,796 ft
SaratogaWest end of the Snowy Range Scenic Byway. The Forest Service district office here covers the Sierra Madre and the west side of the Snowy Range.6,789 ft
Rock SpringsOn I-80 with a BLM field office. The road to the Killpecker Sand Dunes leaves US 191 to the north, and the BLM’s 24-mile Pilot Butte Wild Horse Scenic Tour starts here.6,388 ft
JacksonBase for Grand Teton. The highway north to Flagg Ranch is plowed all winter. The Forest Service says camping nearby often fills by late morning in summer.6,238 ft
CheyenneState capital, where I-25 crosses I-80. The BLM’s Wyoming State Office is here.6,092 ft
LanderAt the foot of the east slope of the Wind River Range. Shoshone National Forest district office and a BLM field office.5,356 ft
CasperBLM field office. The South Bighorn/Red Wall byway starts 13 miles northwest on US 20/26, and Alcova is 30 miles out on Highway 220.5,105 ft
CodyShoshone National Forest headquarters, about 50 miles from Yellowstone’s East Entrance. The Chief Joseph byway leaves Highway 120 sixteen miles north.5,000 ft
BuffaloEast end of the Cloud Peak Skyway, US 16, over Powder River Pass. Full services and a BLM field office.4,640 ft
WorlandHome of the BLM field office that manages Red Gulch/Alkali. Full services west of the Cloud Peak Skyway.4,065 ft
GreybullAll services for the Red Gulch/Alkali byway. The turnoff is 11 miles east on US 14.3,794 ft
SheridanFull services for the Big Horn Scenic Byway, US 14, which climbs west from Dayton to Granite Pass.3,748 ft
Passes, high roads and summits
Gannett PeakThe highest point in Wyoming, in the Wind River Range. No road to the top13,804 ft
Cloud PeakThe highest point in the Bighorn National Forest, by the forest’s figure13,167 ft
Medicine Bow PeakAbove Snowy Range Pass on Highway 13012,013 ft
Beartooth PassBeartooth Highway (US 212): Red Lodge, Montana, to Cooke City and Yellowstone’s Northeast Entrance, across the northwest corner of Wyoming10,947 ft
Snowy Range PassSnowy Range Scenic Byway (WYO 130): Centennial to Saratoga, across the Medicine Bow Mountains10,847 ft
Powder River PassCloud Peak Skyway (US 16): Buffalo to Ten Sleep, across the southern Bighorns9,666 ft
Togwotee PassUS 26/287 between Dubois and Moran Junction, on the Wyoming Centennial Scenic Byway9,658 ft
Granite PassTop of the Big Horn Scenic Byway, US 14 between Shell and Dayton9,033 ft
Pass, road and summit elevations are the figures published by the agency that manages them. Town elevations are the town’s or county’s own
figure where it publishes an exact one; the rest are from the U.S. Geological Survey (3D Elevation Program at the place’s official coordinates),
retrieved September 18, 2026. Every source is listed at the foot of the page.
Free build quotes
Looking for fabricators in Wyoming? Tell us about the project and get free quotes.
