Arches, Bryce Canyon, Canyonlands, Capitol Reef and Zion. The Park Service counts 13 units in Utah and 14,354,141 visits to its national parks
Armor, racks and the 85-inch rule
Width and length are legal limits in Utah, not just packing problems. Elephant Hill allows nothing over 21 feet long or 85 inches wide, and the Maze applies the 21-foot limit north of the Teapot Rock campsite. Anything a fabricator bolts to the outside of the vehicle counts toward those numbers, so ask for measurements at the widest point before the work starts.
Underneath, plan for sandstone ledges and stair-step drops, which the Park Service uses to describe Elephant Hill. Sliders that double as a jacking point matter on deep sand, such as the last sites in Buckhorn Draw.
When a catalog part does not exist for your vehicle, does not fit with what you already have, or is not strong enough for what you do, a fabricator builds it. Steel or aluminum, welded, finished, and mounted so the load goes into structure rather than sheet metal.
They also fix what breaks: cracked mounts, bent sliders, torn brackets and the frame damage that ends trips.
Common work
01Bumpers with winch mounts and rated recovery points
02Rock sliders and skid plates
03Roof racks, bed racks and ladders
04Swing-outs for tires, fuel and water
05Mounts for tanks, compressors and batteries
06Frame and bracket repair
How to choose a fabricator
Metalwork is easy to judge if you know where to look.
01Look at the welds, then at how the part mounts. Recovery points and sliders should tie into the frame.
02Ask whether they design in CAD or build to the vehicle, and whether you get drawings.
03Ask about material and finish. Raw, painted and powder coated parts age very differently.
04Ask if they have built for your platform before. Templates and fixtures save you money.
05Ask how a front bumper affects airbag sensors and crush zones. A shop that has done it properly will have an answer.
What to have ready before you ask for a quote
Photographs do most of the talking.
01Clear photos of the vehicle and the area the part mounts to
02What is already mounted there: winch model, lights, tire size
03What the part has to carry, and how much it weighs
04Steel or aluminum, and the finish you want
05A budget range and your timing
Questions people ask
Custom or off the shelf?
If a well-made part exists for your vehicle, it is usually cheaper and faster than custom, and a good fabricator will tell you so. Custom earns its cost when nothing fits, when parts from different makers have to work together, or when you need it stronger or lighter than the catalog offers.
Steel or aluminum?
Steel is stronger for the money, easier to repair in the field and heavier. Aluminum saves real weight on racks, skid plates and boxes, but costs more and needs a welder who works with it regularly. Many builds use both: steel where it hits rocks, aluminum where it just carries things.
Can a fabricator repair a cracked frame or mount?
Often, yes. Send clear photos with your request. A good shop will tell you whether it can be repaired properly or needs replacing.
How high is Utah?
From St. George at 2,696 feet to Kings Peak at 13,528.
Altitude decides what your engine, your brakes and your lungs have to work with, and how late in the year the passes open.
2,0004,0006,0008,00010,00012,00014,000
Feet above sea level
Towns
MonticelloWhere US 191 meets US 491. BLM Monticello Field Office and a Manti-La Sal ranger district. Nearest services to the Needles, 48 miles away.7,068 ft
TorreyOn Highway 24 at the west end of Capitol Reef, where Highway 12 comes over Boulder Mountain. The park’s visitor center and the Cathedral Valley turnoffs are just east.6,841 ft
BoulderOn Highway 12 at the west end of the Burr Trail, which is paved from here to the Capitol Reef boundary and graded dirt after it.6,704 ft
BlandingOn US 191 where Highway 95 heads west. The Park Service puts Natural Bridges and Hovenweep here, and the BLM puts Kane Gulch, the Cedar Mesa permit station, 36 miles away.6,104 ft
Cedar CityOn I-15, with Cedar Breaks National Monument in the mountains above. BLM Color Country District and the Dixie National Forest supervisor’s office.5,845 ft
EscalanteOn Highway 12 in Grand Staircase-Escalante. The Hole-in-the-Rock Road starts here and runs 62 miles southeast; a Dixie ranger district and the interagency visitor center are in town.5,813 ft
PriceOn US 6 with the BLM Price Field Office and the Manti-La Sal supervisor’s office. Nine Mile Canyon leaves from Wellington, just southeast, and the San Rafael Swell is south.5,561 ft
VernalOn US 40 in the northeast. Ashley National Forest headquarters and BLM Green River District, with Flaming Gorge and Dinosaur to the north and east.5,332 ft
KanabOn US 89 in the far south. BLM Paria River District and the Grand Staircase-Escalante office, which runs the Coyote Buttes and Paria Canyon permits. The Cottonwood Canyons backway meets US 89 about 64 miles east.4,970 ft
BluffOn US 191 above the San Juan River. The BLM’s Sand Island recreation area, with a campground and a boat ramp, is just outside town, and Valley of the Gods is 15 miles west.4,325 ft
HanksvilleHome of the BLM’s Henry Mountains Field Station, with the Bull Creek Pass byway leaving Highway 95 about 21 miles south. Nearest services to Hans Flat and the Maze, 61 miles away.4,303 ft
Salt Lake CityWhere I-15 meets I-80. BLM Utah state office and West Desert District, and the city below Big and Little Cottonwood Canyons, where the traction law is strictest.4,264 ft
Mexican HatWhere US 163 meets Highway 261 below the Moki Dugway. The east end of the Valley of the Gods road is seven miles away.4,253 ft
Green RiverWhere US 6 leaves I-70. The BLM sends San Rafael Swell visitors west from here, and the Park Service puts Hans Flat 84 miles away.4,070 ft
MoabOn US 191 between Arches and Canyonlands. BLM Canyon Country District and Moab Field Office, and the nearest services to Island in the Sky, 32 miles away.4,032 ft
St. GeorgeOn I-15 in the southwest corner, the lowest of these towns. A BLM field office and a Dixie ranger district; the Smithsonian Butte byway is east, below Zion.2,696 ft
Passes, high roads and summits
Kings PeakThe highest point in Utah, in the High Uintas Wilderness. No road to it13,528 ft
Blue Bell KnollThe high point of the Dixie National Forest, on Boulder Mountain above Highway 1211,322 ft
Bald Mountain PassThe high point of the paved Mirror Lake Scenic Byway, in the Uintas10,715 ft
Bull Creek PassBull Creek Pass Back Country Byway: A loop through the Henry Mountains, between Capitol Reef and Canyonlands. It leaves Highway 95 about 21 miles south of Hanksville10,478 ft
Pass, road and summit elevations are the figures published by the agency that manages them. Town elevations are the town’s or county’s own
figure where it publishes an exact one; the rest are from the U.S. Geological Survey (3D Elevation Program at the place’s official coordinates),
retrieved September 18, 2026. Every source is listed at the foot of the page.
Free build quotes
Looking for fabricators in Utah? Tell us about the project and get free quotes.
